Responsible to work as sub section Incharge and manage general shift duties accordingly
 Responsible to lead fault tracing & troubleshooting guides to trace and fix operational faults with
the help of schematic drawings, catalogues etc.
 Responsible to manage shut down inspection schedule regarding predictive maintenance and
PPM schedule (weekly, fortnightly, & monthly).
 To supervise SKF monthly reports regarding motor vibration, thermography etc.
 To supervise and verify relays settings and coordination data suggested by EPESOL.
 Responsible to remain in touch with environment team to discuss environment monitoring
reports on dust, smoke (boiler case) and noise for, safe environment at plant mission.
 Checking the weekly inspection report of 500 KVA emergency generator.
 Inspection and running of boilers and delivering its status report to utility staff.
 Supervising daily monitoring and visual inspection of transformers ( i.e 2000 KVA, 1600 KVA, 800
KVA ) , LT/HT motors and Simoverts (frequency drives) in area.
 Inspecting and supervising daily maintenance on Bottom (Kiln Inlet) and Top (Kiln Outlet) gas
analyzers.
 Inspecting Monthly AQMS station Analyzers . (NOx, SOx, CO, O3 & Dust (PM 10, PM 2.5)
 Responsible to daily update of UPS and smart energy meter history sheet.
 To monitor the earth pits resistance using earth tester (module KEW 4106) and checking lightning
arresters conditions for safety hazards.
 Attended seminars to get familiar with ISO 14001, ISO 9001 and ISO 9002, Environment safety,
PRESCON on predictive maintenance, self-safety etc.
 Worked on the up gradation of FLS Kiln Pfisters (Main & Calciner ) , Supervised the whole project
under the guidance of senior Engineers.
 Got familiar with different type of power sources being used in D.G.K.C.C.
 Got familiar with advanced networking system (CISCO / SCADA).
 Daily working with temperature and pressure sensors i.e PT100, PT1000, Cerabars ,deltabars ,
proximity sensors , levels, K&J type thermocouples, limit switches, solenoid valves etc.
 Working effectively in coordination with instrument, power and PLC teams for better working
of plant (being a part of strong team work).

Up gradation of Kiln Pfisters (Main & Calciner)
 Installation & Commissioning of KilnLoq Gas Analysis System ( for Kiln Inlet)
 Refurbishing Kiln Burner System.
 Refurbishing Kiln Ignition System.
 Installation of 650Kvar Capacitor Bank for Power Factor Improvement.
 Up gradation of compressed air system’s electronics ( Pressure sensors,Temperature
sensors,& HMI screens for compressors & dryers )

 Coal Fired Power Plant DG Khan Cement Company Limited (30 MW). Learned about power generation and
distribution system, Power System Protection used at plant and load management at P.U